1.Moisten a clean sponge and wipe your bisque to remove any dust or dirt.2.Using tracing paper, have each of them trace the dragonfly design provided onto their bisque.3.Make a color wash by mixing equal amounts of water with SC-43 Lettuce Alone on your palette. Then, using your soft fan brush, apply 1 coat as evenly as possible to the background of the piece (all around the dragonfly - try not to get any on the dragonfly).4.Next, using the CB-308 Flat Shader, make a border around your piece by loading your brush with SC-15 Tuxedo. Place your brush approximately ¼" inside the rim of the plate and pulling it directly outward. Then, move the brush to the left, leaving a 1" gap from the last stroke, and repeat this process. This will create a semi-checkered border (see photo sample).5.Using SC-4, 6, 7, 11, 18, 43, and 70 fill in the various sections of the dragonfly's wings. Apply two coats of glaze to each section. Use the project photo as a guide - repeating the exact color pattern and placement is not as critical as is choosing shades and the colors you place next to them. Imagine what a dragonfly's wings look like and try to capture the iridescent quality of their wings.6.Using SC-4 Salsa paint the dragonfly's mouth.7.Use SC-6, 11, 18 and 70 to fill in the sections of the Dragonfly's body. Again, apply no more than two coats.8.Now, it is time to add the "iron piping." Carefully and slowly squeeze the writing tip bottle filled with AC-306 Clay Mender and trace over the lines of the dragonfly. The dimension of the clay mender will hold up during firing.